FAQ
If the dust is not being stopped by the filter and is being exhausted out of the blower port and back into the air, this can be caused by a hole in the filter, the filter not being properly installed, or the dust being too fine for the filter. Please remove and reinstall filter.
The most common causes of loss of suction are dirty filters or a clog in the hose. Remove the hose, place your hand at the tank inlet, and turn the vacuum on. If you feel suction, check the hose and accessories for clogs or cracks. Replace the hose if any crack or hole is found.
Sucking up several substances can eventually clog the filter if it is not maintained. Please uninstall the foam filter, wash it, and try again.
This is the blower port. You can connect your hose to this port and use it as a blower for leaves in your garage, driveway, or walkway. Many blower ports are open and do not have a cap, which is normal.
It is recommended that the compressor is plugged directly into the wall outlet. If an extension is necessary, consider using a longer air hose instead.
Adjust the regulator to set your desired tool-side pressure.
Please make sure the compressor is plugged in, check for leaks, and turn the regulator knob counterclockwise to build tank pressure before adjusting it for tool-side pressure.
Please use type M quick connectors.